plastics 2010
  • » Plastics 2010 Home
  • » About the Seminars
  • » Facilities
  • » Instructors
  • » Registration
  • » Directions
  • » Hotel & Travel
  • » Onsite Training
RELATED LINKS
  • » UML Website
  • » Plastics Dept.
  • » Continuing Studies
Directions to the University

Lowell is located conveniently between two major airports: Boston's Logan Airport and the Manchester, NH Regional Airport. Click here for Hotel and Travel Information. Attendees flying in for the seminars will need to arrange for daily transportation between their hotel and the University campus.

The University of Massachusetts Lowell is located approximately 25 miles northwest of Boston, and is easily accessible from Routes 3, 93, 95 and 495. All seminars are held on the University's North Campus in Ball Hall. map
skymap

If you want to map out your own route via the Internet or GPS system, below is the address to get to Ball Hall on UMass Lowell's North Campus:

Ball Hall
185 Riverside Street
Lowell, MA 01854

Riverside Parking Lot
42 Sparks Street
Lowell, MA 01854

From Rte 495:
Take Exit 35C to the Lowell Connector.*

From Rte 93:
Take Rte 93 North or South to Exit 46, Rte 110 West towards Lowell following the Merrimack River. In Lowell, Rte 110/38 exits off to the right but you should stay to the left, continuing straight and going under the overpass, keeping the river on your left. After approximately 2 miles up, take a right onto University Ave. Ball Hall is the 3rd building on the right, at the corner of University Ave and Riverside Street.

From Rte 3 North:
Take Exit 30B to the Lowell Connector.*

From Rte 3 South:
Take Exit 30A towards I-495 North-IMMEDIATELY take Exit 35C to the Lowell Connector.

From Rte 95/128:
Follow Rte 95/128 North or South to the Burlington area and take Rte 3 North. to Exit 30B, the Lowell Connector.

Directions from Logan International Airport:
Exit Logan Airport and follow signs for Rte 1A South towards Interstate 93/Sumner Tunnel/Boston. Go through the toll booth and continue on through the Sumner Tunnel. Stay left upon exiting the tunnel and merge onto I-93 North. Continue on I-93 to Exit 46, Rte 110 West towards Lowell following the Merrimack River. In Lowell, Rte 110/38 exits off to the right but you should stay to the left, continuing straight and going under the overpass, keeping the river on your left. After approximately 2 miles up, take a right onto University Ave. Ball Hall is the 3rd building on the right, at the corner of University Ave and Riverside Street.

Directions from Manchester Airport:
Take a right onto Brown Avenue and go straight through three sets of lights. After 3rd light, take a left onto Rte I-293. On I-293 head toward Bedford. Take the Everett Turnpike South, which becomes Rte 3 South once you cross the state border into MA. Follow Rte 3 South, and take Exit 30A towards I-495 North-IMMEDIATELY take Exit 35C to the Lowell Connector.

*Directions From the Lowell Connector:
Take Exit 3, Industrial Ave. Bear right off the exit ramp, onto Industrial Avenue. You will pass through a rotary, but continue straight on Industrial Avenue, up an incline to your first set of lights. Go straight through the lights onto Stevens St. Follow Stevens St. for approximately 1.5 miles, then turn right onto Middlesex St. Take the first left onto Wilder St. and follow to the end (past UMass Lowell South). Turn right onto Pawtucket St. and then take the 2nd left (just past the hospital and nursing home) over the University Avenue Bridge. Ball Hall is the third building on the right, at the corner of University Avenue and Riverside St.

Plastics Seminars & Workshops are held on UML North in Ball Hall (Bldg # 1 on the map below).

Parking:There is parking available off Riverside St. in the Riverside Lot, which is about 1/4 mile down from the corner of University Ave. and Riverside St. the entrance to the lot is at the far end. For a detailed campus map of UML North, click here.

© 1995-2009 University of Massachusetts Lowell,
Continuing Studies, Corporate & Distance Education